HOUR METERS
I purchased your hour meters for my new four stroke and the coil must be built into the plug cap as it doesn't have a coil wire. is there another way to connect it?
The new four-strokes (YZF, CRF, KXF, etc..) have the coil mounted right on top of the spark plug, thus there is no coil wire running down to the plug like the old days!

No problem, our hour meter will still work. Wrap the wire around the circumference of the boot that covers the spark plug. A few revolutions around this boot will suffice.

This is the easiest way.

Another alternative is to splice into the kill switch wire that goes up to the handlebars.

How do I get my stickers to line up straight?
Use Sticker-On! Decal Application Fluid. Just spray it on the back of the decal and it allows you to slide and position the decal into place. No more bubbled or wrinkled decals!

Do I need the large bottle of Sticker-On! or will the 2 oz. version do?
The large bottle is for dealers who do a lot of OEM decal replacement. The 2 oz. version is more than sufficient to install your registration numbers, logo decals, racing numbers, backgrounds and other decals.

How do I get my old decals off?
Use a hair dryer to warm the decals and they should peel right off. Do small sections at a time. If you use a heat gun, be careful not to burn your paint or finish.

How do I remove the adhesive from the old decals?
Use Sticker-Off! Decal Adhesive Remover. Just spray it on the adhesive, allow a few minutes for the product to penetrate and then wipe away with a clean, soft cloth.

Where do I put my registration numbers?
The law mandates that your registration numbers must be on the forward half of the vessel above the waterline in colors contrasting with the background of the application area.

Why does your carbon fiber pattern look better than the other ones I have seen?
Our pattern was designed exclusively by our in-house artist. It took months of testing to come up with a carbon fiber pattern that looked great and matched industrial carbon fiber but worked in every color combination. We are the original producers of the "Factory Matched Carbon Fiber Number Kit" and it shows when you see the product.

What do I do if I have three of the same digits in my registration sequence?
Occassionally people are assigned a registration number that has three of the same digits in each sequence. Our packages come with 4 sets of A-Z and 4 sets of 0-9 so you will be short 2 digits. Send a self-addressed envelope to Hardline Products, 677 Cochran St., Simi Valley, CA 93065 with the part number from our package and the letters or numbers you need and we will send them to you free of charge. Please allow a few days turnaround time to receive your decals.

The clamps in your ATV License Plate are too small for my quad. What do I do?
Make sure you are installing the ATV License Plate Kit in the proper area. The proper area should be your grab rail in the back of your quad or the luggage rack. If the clamps are still too small, try removing the rubber grommets that are wrapped around each clamp. If the license plate clamps are still too small, use the wire ties that are included in each package for installation.

If I buy your ATV License Plate Kit, can I ride my Quad on the road?
Our ATV License Plate Kit does not make your ATV street legal. Some states do allow ATV's to be used on the road when outfitted with the proper equipment. However, the ATV License Plate Kit is for displaying your off- road registration decal and/or assigned numbers on the back of your ATV.